Comdial FX Series Spezifikationen PDF herunterladen (Seite 50)

FX II Hardware Introduction

GCA39-824 Rev 2, Issue 4/02 Page 36 Printed in the USA

FX II Installation and Application Guidelines

• The FX II can accept the FXT/FXS FXCPU-2 board mounted to the FXSRV-EX as long as it

is at least REVISION P. The FX II cannot support the FXINT-XSRV boards from FXT/FXS

family of SCSI Expansion products.

• You can expand an FXS main cabinet with FX II expansion cabinets. The FXS will need an

FXCPU Rev. P or higher, FXSRV2-II, FXINT-MAUXII, and the FXII-480 software. You

can then add the FX II expansion cabinet(s) with the appropriate expansion kits based upon

the customer's needs.

• To use a single cabinet FX II system with 96 port software in either ISDN or VoIP

Networking, follow these guidelines:

• As a node it can be equipped with the original FXCPU-EX/FXSRV-EX.

• As a hub it will need the FXCPU-2 to replace the FXCPU-EX. You can install it on the

FXSRV-EX.

• Keep in mind that the FX II 96 port system can only have 4 FXNET boards installed so it

may not be utilized as a hub in a large network.

• You need at least 16A 180 software to run VoIP Networking.

• You need at least 17A 190 to install iPrimo phones

For more guidelines, see the table on the following pages.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 251 252

Keine Kommentare

Comdial FX Series Spezifikationen Seite 50